• Home   /  
  • Archive by category "1"

De0 Nano Pin Assignment In Proportional Valves


  1. June 9th, 2013, 01:42 PM#1

    DE0-Nano Pin Assignment setting file problem

    Hello people,

    When I create a project I immediately import the DE0 nano settings file with the pin assignments. In the block editor file though when i use only one or two output pins of the chip like GPIO_1[16] the specific pin gets ignored and when i compile it at the pin assignment I see the output pins I added as extra pins like GPIO_116 and not assigned to the pins I wanted.

    Anybody has any idea why?

    Thanks
  2. June 9th, 2013, 09:24 PM#2
    Join Date
    Jun 2007
    Location
    Weikersheim, Germany
    Posts
    279
    Rep Power
    1

    Re: DE0-Nano Pin Assignment setting file problem

    Not sure (being not familar with the block editor),
    but have you declared the GPIO_1 as the whole vector and are just using the two bits or have you declared only the two bits required (thus the compiler may not detect these two pins as part of the vector).

  3. June 9th, 2013, 09:57 PM#3

    Re: DE0-Nano Pin Assignment setting file problem

    Thanks for the answer!

    No I use only the two pins I need (GPIO_1[16] and GPIO_1[22]).

    How can I make a declaration inside the block editor?
  4. June 9th, 2013, 10:07 PM#4
    Join Date
    Jun 2007
    Location
    Weikersheim, Germany
    Posts
    279
    Rep Power
    1

    Re: DE0-Nano Pin Assignment setting file problem

    Hi,
    thus I'd suggest to either rename your's two pins, delete the assignment for GPIO_1 and assign the pins to these two signals or to assign a fixed signal (either '0' or '1') to the other members of GPIO_1 to have the vector being recognized...

  5. June 9th, 2013, 10:50 PM#5

    Re: DE0-Nano Pin Assignment setting file problem

    Thanks for the reply!

    My problem though is that I have created a board with some levelshifters and the FPGA is mounted on. Some GPIO pins of the FPGA are connected to inpout-outputs of the levelshifters. The first thing I need to do is to assure that the output of the levelshifters is off so that there is no double drive on a specific line. Maybe I should create the block file and then import the pin assignments.

Similar Threads

  1. Replies: 1
    Last Post: September 15th, 2013, 11:00 PM
  2. Replies: 1
    Last Post: March 7th, 2013, 06:16 PM
  3. Replies: 2
    Last Post: March 7th, 2013, 11:18 AM
  4. Replies: 5
    Last Post: November 21st, 2011, 07:55 AM
  5. Replies: 4
    Last Post: June 27th, 2009, 12:26 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules


Халохот ликвидировал его с помощью НТП - непроникающей травматической пули. Это резиновая капсула, которая при попадании растворяется.

Все тихо и чисто. Перед сердечным приступом мистер Танкадо не почувствовал ничего, кроме легкого укола.

One thought on “De0 Nano Pin Assignment In Proportional Valves

Leave a comment

L'indirizzo email non verrà pubblicato. I campi obbligatori sono contrassegnati *